Here are some 3D-printable dividers for the Simply Tidy “16 Case Photo & Craft Keeper” ****project/photo tubs (the ones with 16 removable clamshell cases).

OnShape document

Onshape

Notes

• I’ve only test-printed the Hamburger version!!! Some dimensions may still need tweaking/sanding. I’ll update this as I go.
• The design is not a faithful adaptation of the clamshell box, so if you’re doing something complicated, watch out :)
• All the names are very short, because my printer refuses to detect files with long names.

Parts

• HBurg: “hamburger-style” split: top to bottom, two square-ish compartments
• HDog: “hot-dog-style” split: side to side, two long compartments
• Qtrs: in quarters
• Bento: hamburgers, but the right one is split in half side-to-side to give 1 big compartment and 2 smaller ones.
• Dmd: five compartments – four corners around a central diamond shape. Good for 2” diameter stickers, patches, whatever.

Variables

• ThickWall (1.5mm): default divider wall thickness
• HighWall (27.5mm): default divider wall height at the center
• OW (162mm): outer width = the inside width of the box, at the wider corners
• IW (152mm): inner width = the inside width at the narrower middle sections
• OH (108mm): outer height = the inside height (Y-axis) at the wider corners
• IH (103.5mm): inner height = the inside height (Y-axis) at the narrower middle sections